Subject	So I just pulled an injector
Posted by	en5 on September 16, 2008 at 6:49 PM
	This message has been viewed 106 times.
Message	And a bunch of gas (even though I "relieved the pressure") decided to pour into the cylinder. How long should I wait to install the new injector to let whatever pooled in the cylinder to evaporate. Because it really seemed like a fair amount of fluid to be honest, like not the entire contents of the fuel rail but enough for it to pour out, not trickle.
Follow Ups	So I just pulled an injector - en5 18:49:15 09/16/08 Pull the spark plugs/CAS connector and turn it over - SilverTwin(OH) 19:16:55 09/16/08 Did you remove the plenum too? If so, you can sop most - jmw23712 19:22:13 09/16/08 It went into the cylinder... - en5 22:32:07 09/16/08 Change your oil before you run it again - Turbodog (CT) 11:39:11 09/17/08
Post a Followup	You cannot reply to this message because you are not logged in.