Subject	I have one mocked up on my engine right now
Posted by	jspeckid on September 16, 2008 at 5:55 PM
	This message has been viewed 85 times.
In Reply To	Mine takes about 7qts - just under - IIRC. (n/m) posted by Scotts94z32 on September 16, 2008 at 05:35 PM
Message	Were you able to get both trans brackets bolted up to the engine with the pan on? A local guy said he could only get one of the two on beacuse the pan sticks out so far.
Follow Ups	finally got the SZ 6-quart oil pan great work guys thanks - Z-Roc@NEWOrleans 11:55:52 09/16/08 Nice! - LitlElvis 12:46:57 09/16/08 Have you tested the quart capacity? (n/m) - AZHeat 13:28:52 09/16/08 I only got 6qts when I measured volume. (n/m) - tech@EPR 13:33:22 09/16/08 not yet making custom gasket for it (n/m) - Z-Roc@NEWOrleans 13:36:23 09/16/08 Why would you need a custom gasket? The oil pans take - AZHeat 17:39:37 09/16/08 We're still waiting on the results from your oil pan tes.... - ENVYMYZ 15:21:04 09/16/08 He actually did - ZXRider(SoCal) 15:53:09 09/16/08 ouch.. sick burn (n/m) - zxtuner161 17:05:00 09/16/08 His 'general forum' post history did not yield any - ENVYMYZ 20:43:10 09/16/08 The "turd talking" is on hold. I am still settling in - AZHeat 00:03:50 09/17/08 Mine takes about 7qts - just under - IIRC. (n/m) - Scotts94z32 17:35:47 09/16/08 I have one mocked up on my engine right now - jspeckid 17:55:43 09/16/08 On mine, I used spacer washers and longer bolts - AZHeat 18:17:21 09/16/08 How much did it run ya if you don't mind me asking... (n/m) - KongZTT GT28RS MD 15:43:56 09/16/08 I was quoted $550, plus an OEM oil pan, and there's a wait - zgene4 17:48:16 09/16/08 not too bad (n/m) - KongZTT GT28RS MD 09:38:24 09/17/08 Nice. *thumbs up* (n/m) - Milo (SATX) 17:31:14 09/16/08 Got mine just the other day too! - collegeboy 18:42:01 09/16/08
Post a Followup	You cannot reply to this message because you are not logged in.