Subject	i purchased the car about a month ago
Posted by	ricky6991 on September 12, 2008 at 2:48 AM
	This message has been viewed 112 times.
In Reply To	dyno'd the z posted by ricky6991 on September 12, 2008 at 01:19 AM
Message	i bought it for 4g's origional owner he said completely stock... i finally got around to hooking up boost guage(aftermarket) it said i was runing 6psi. i ran codes got 55. so i said screw it. i checked all my hoses and plugs. everything was good so i installed the manual boost controller. went up the street on 16lbs. a entirly diffrent car. dunno why i was only on 6psi to begin wiht. so i drove it to the dyno and put it on to check air fuel an everything. i bought somone that dyno tunes and said he wished i had apexi so he could lean it out for me or atleast fuel pressure regulator. i asked if 16 was good cause whole ride there i had no smoke nothing. he said if i wnated i could easily raise the boost. ecu looks stock maby i should open it up before i get my chip mailed lol. i did about 5 runs. 4 on 16lbs an all the same just about power wise. i then disconnected the boost controller for a run they way it was an how i been driving it on 5psi an i put down 166rwhp. so i left it at 16 beat the hell out of it all day wiht no once of smoke , cut out, nothing. jsut more power.
Follow Ups	dyno'd the z - ricky6991 01:19:52 09/12/08 The best place for you fuel to be is 12.5 to one on boosted - Sleeper_TTZ(SeKy) 01:48:19 09/12/08 yeh thats not very smart.... (n/m) - RedTTZ91(OK) 01:49:27 09/12/08 A/F Ratio Chart - z-spott[HI] 02:19:56 09/12/08 Ok so he's not running lean i was wrong... So that - Sleeper_TTZ(SeKy) 02:33:51 09/12/08 10:1 is rich, not lean. - ZLover4Life 02:31:04 09/12/08 I haven't had the pleasure of Dyno tuning yet... sorry... - Sleeper_TTZ(SeKy) 02:36:57 09/12/08 I vote he has upgraded parts hes not aware about...at 15 - RedTTZ91(OK) 02:37:30 09/12/08 Thats what i'm thinking... If so lucky him... If not still - Sleeper_TTZ(SeKy) 02:41:33 09/12/08 I guess if no intake or exhaust maybe about right, but - RedTTZ91(OK) 02:44:11 09/12/08 no intake and no exaust (literally) - ricky6991 02:50:48 09/12/08 A/F ratio is based on mass, not molecules (n/m) - aliaZ 06:27:27 09/12/08 I know that. lol The MAF can't count air molecules... - ZLover4Life 10:39:08 09/12/08 ?????????? To everyone on this thread. - phillyz 06:06:18 09/12/08 very sweet sig pic (n/m) - Ahmed (Chicago) 07:41:56 09/12/08 i have read threads on here... - ricky6991 10:40:05 09/12/08 >>> - ztunerz 13:39:39 09/12/08 i purchased the car about a month ago - ricky6991 02:48:13 09/12/08 well im stumped, wish bernie or someone was up lol (n/m) - RedTTZ91(OK) 02:50:32 09/12/08 go take pics of the top of your motor around your injectos - RedTTZ91(OK) 02:51:29 09/12/08 give me 10 min ill be on wiht them - ricky6991 02:55:02 09/12/08 Re: dyno'd the z - ricky6991 03:04:54 09/12/08 I honestly don't know... My stock injectors are grey on top. - Sleeper_TTZ(SeKy) 03:18:50 09/12/08 I would take a minute and clean those connectors! (n/m) - Audioquest 09:04:11 09/12/08 Looks like stock Injectors 2 me - PearTT (MD) 12:19:27 09/12/08 sum up: for people that would like to shed some insight - ricky6991 03:45:17 09/12/08 something is VERY wrong. id figure it before it goes boom - AntiHero 08:31:42 09/12/08 Re: dyno'd the z - onewheelf4 05:06:24 09/12/08 You hook up the two wastegate actuators with a T connector. - phillyz 06:09:04 09/12/08 i did everything correctly. i used all write ups from here. (n/m) - ricky6991 10:16:49 09/12/08 Either the shops WB was not operating properly, - Agner.S(CT) 07:57:16 09/12/08 I would have thought your buddy's Z should have put - jlag 08:00:34 09/12/08 reliably? (n/m) - gt300zxtt 09:35:57 09/12/08 I made more at 12psi on stock Auto turbos. (n/m) - Spddracer 11:40:17 09/12/08 hey spddracer. i sent you an email about the chip. - ricky6991 11:48:38 09/12/08 >>>>>>>>> - LJZTT 08:05:32 09/12/08
Post a Followup	You cannot reply to this message because you are not logged in.