| I got several e-mails asking for more picture of the hardware that comes with the SZ turbo kit so I took a couple just now. Also had some people asking about the Craftsquare mirrors and my secondary fuel pump I'm running. The second fuel pump is an Aeromotive unit that has it's own fuel filter also, and it taps into the gas tank via a 3/8 NPT fitting, and connects to the existing fuel braided fuel lines via an Aeromotive 6an Y fitting. It is not needed until you get over the 700rwhp level, so it can just be turned on with a switch I have in the cabin whenever I have race gas in the tank. This is the setup Greg at SZ has on his car so I figured it would suffice for me as well. 
Oil Line Connection
 Coolant Line Connection
 Pipes just sitting in place
 Forge Actuators (Not chrome haha)
 Terrible Picture of Craftsquare mirrors. Oddly these actually allow you to see more than stock because they are both convexed.
 Secondary fuel pump/secondary fuel filter setup. the fuel pump is a good 18" away from an exhaust pipe so I figure that is far enough correct? I took this picture a while ago. All the lines and all are hooked up now and wrapped in heat protectant sleeves to for what it's worth. Yea...it's dirty under there from sitting for a year. =( Anyways, I hope this helps someone wanting the pictures.
Thanks,
Mike
1991 Black 3.0 Twin Turbo La-Z-Link
^^Hard engine break in method^^
La-Z-Link
^^MY FACEBOOK...CHECK IT OUT^^ 
---Me: You bought a Porsche?
---sfpearl300z: lol, no no, I have a decent sized penis so no need for that.
"felt wierd fingering my exhuast for 1hr with no results :(" - zboost
"lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z
"I think I'll pass on giving my car a handjob" - joel(PA)
"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21 |
More Pictures of SZ Turbo Kit, Mirrors, and Second Fuel Pump - 
