Subject	Suggestions on wheel spacers?
Posted by	AshsZ (In Florida) on June 11, 2001 at 9:28 PM
	This message has been viewed 37 times.
Message	The 18" MoMos I got have the wrong offset and are about 1/2" too far in, cosmetically. They clear the calipers and the shocks on the inside, but the front and the rear dont fit flush with the outer lip of the wheel well. The original studs aren't long enough to just add spacers so they will have to be replaced. Can anyone suggest a stud to use? I would like something that will hold up to the projected 400 or so HP and not twist off. :-( Suggestions on manufacturers? ThxZalot! My CarPuter Headquarters: [ ashleypowers.terrashare.com ] agpowers@bellsouth.net
Follow Ups	Suggestions on wheel spacers? - AshsZ (In Florida) 21:28:07 06/11/01 Fabricate some, King Fab Whore! (n/m) - NA300ZX (TPA, FL) 21:47:00 06/11/01 I install pre-fab partz too. :-) I'm not totally insane. (n/m) - AshsZ (In Florida) 21:51:39 06/11/01 What kind of exhaust is that :) (n/m) - oOoEveroOo 22:40:22 06/11/01 Well, it's been a while since I pimped Naxos, so here goes > - AshsZ (In Florida) 09:24:07 06/12/01 use H&R Spacers they come with upgraded longer studs (n/m) - Carlos Ramirez 23:17:26 06/11/01 never heard of them - got a link? (n/m) - AshsZ (In Florida) 09:43:41 06/12/01 you can get them from www.optauto.com (n/m) - Carlos Ramirez 10:50:18 06/12/01 Nissan Motorsports sells a longer stud for racing (n/m) - NSANY(ATL) 05:16:12 06/12/01
Post a Followup	You cannot reply to this message because you are not logged in.