| Message |
When I bought it I shopped around for the highest CFM @30, 60, 90 PSI I could find rather than just HP and tank size etc, but I cant remember what the figures are anymore. I'd still have to buy guns and a lot of materials so I dont think it would be extremely cheap, it's more so the experiance that I'm after rather than just to get it done cheap. The other thing is that once I put it in the garage there will be a few feet of snow on the ground so I wont be able to pull it out to wash it. Keeping everything clean and well ventalated so it's not a huge dustbowl by the time I go to spray is gonna be tough to say the least. Also cant even decide what I want to do as far as prep, whether I want to use a chemical stripper or a DA sander, and then whether I should go to bare metal or just take down the problem areas and ruff the rest of it up. It's definately a lot to think about.
|
 |
