Subject	Cool, maybe Damon took my advice. :-) On that, Damon >>>
Posted by	AshsZ (In Florida) on June 10, 2001 at 3:30 PM
	This message has been viewed 12 times.
In Reply To	wtf??? "no messeges" im technical forum? posted by dogpile on June 10, 2001 at 03:17 PM
Message	the presure sensor, you showed that pin A (left) was ground and pin C (right) was +5V and center (B) was signal. Well, you got the polarity wrong. With the clip on top of the harness connector and looking directly at the contacts, A and C are swapped. I think you may have been referencing them from looking at the end where the wires go in, rather than looking at the contacts themselves. It would be reversed in this case. Were you referencing them like that? I got it working, but I had to disconnect it and take it in the house to put it on the bench to figure it out. Thanks for the help though.. : just clicked on the technical forum button , and this is what i got: : works now though, just wondering if i was special for awhile or not My CarPuter Headquarters: [ ashleypowers.terrashare.com ] agpowers@bellsouth.net
Follow Ups	wtf??? "no messeges" im technical forum? - dogpile 15:17:34 06/10/01 I think Zers are getting smart now. (n/m) - timz 15:18:51 06/10/01 is that boss mode? (n/m) - 3 double-0 ZX 15:28:14 06/10/01 yup. never changed it back from work. like it better tho (n/m) - dogpile 15:39:36 06/10/01 Cool, maybe Damon took my advice. :-) On that, Damon >>> - AshsZ (In Florida) 15:30:48 06/10/01 deffently looking at where the wires go in. thanks - dogpile 15:40:52 06/10/01 Re: Cool, maybe Damon took my advice. :-) On that, Damon >>> - Dallas DamonZ 15:52:42 06/10/01 It's not my board.. My comment was made in jest -> - AshsZ (In Florida) 16:19:34 06/10/01
Post a Followup	You cannot reply to this message because you are not logged in.