Subject	Does that mean my shocks/springs are shot? how do I check?
Posted by	FuerGrissa on June 25, 2008 at 12:22 PM
	This message has been viewed 97 times.
In Reply To	I'm not sure why you're rubbing with that offset. posted by Scotts94z32 on June 25, 2008 at 11:24 AM
Message	I measured it via the FAQ doc, Im pretty sure it's correct. 1. I measured from the mounting surface to the back of the rim (straight edge over the back lip) 2.Then I measured the overall width of the rim (outer lip to outer lip not bead to bead) divided by two to get the halfway point of the rim. 3. then subtracted it from the backspace measurement. I doubt everything is accurate to the mm, but Im pretty sure 30mm +/- 2 is the offset. If this is a perfectly acceptable tire size, then does that mean my springs/shocks are bad? How can I check them?
Follow Ups	Will this look rediculous? - FuerGrissa 10:05:49 06/25/08 Are you not going to replace all four tires? - Z_Cherub 10:19:32 06/25/08 I wasn't going to, the back fit perfect and 60%~ left - FuerGrissa 10:21:35 06/25/08 I see. Sorry I can't offer more help. I don't really know - Z_Cherub 10:54:21 06/25/08 The guy at Goodyear told me this was from a suspension issue - FuerGrissa 10:26:33 06/25/08 I run a 245/40 17 with out issue. (n/m) - Barry (NJ) 11:04:58 06/25/08 The fender lining doesn't seem all there. That is not much - MrPulldown 12:57:23 06/25/08 I do now, that fender lining on the rear of the well - FuerGrissa 13:43:32 06/25/08 I have an old fender liner if you need. - MrPulldown 14:54:54 06/25/08 I'm not sure why you're rubbing with that offset. - Scotts94z32 11:24:42 06/25/08 Does that mean my shocks/springs are shot? how do I check? - FuerGrissa 12:22:15 06/25/08 They could be - IDK. Your math appears correct unless you - Scotts94z32 15:05:17 06/25/08 Spring and shock - MrPulldown 16:31:50 06/25/08
Post a Followup	You cannot reply to this message because you are not logged in.