General Forum
Subject	So I tore into my engine today
Posted by	cossiemodo2000 on May 29, 2008 at 8:38 PM
	This message has been viewed 767 times.
Message	for those of you who read my post yesterday about my headgasket going, well the compression test confirmed, both cylinders 1 and 3 had low compression, well here are the pics, on a side note, why is it the the piston in cylinder 1 is so clean compared to the rest? sorry for the large pics, block seems to be fine, what you guys think?
Follow Ups	So I tore into my engine today - cossiemodo2000 20:38:31 05/29/08 still need to check the deck - gt300zxtt 20:45:52 05/29/08 yes I did here you go - cossiemodo2000 20:51:59 05/29/08 did you happen to keep the head bolts in order when you took - gt300zxtt 20:59:26 05/29/08 hmmm could be, no i didnt keep them in order - cossiemodo2000 21:05:17 05/29/08 wise decision. how much does shipping cost? (n/m) - Ashman2k2 22:31:59 05/29/08 I would be surprised - Dallas DamonZ 22:44:38 05/29/08 I am gessing this is what happend, but all bolts did - cossiemodo2000 23:23:33 05/29/08 what if there were no shorties - gt300zxtt 23:47:13 05/29/08 Re: what if there were no shorties - Dallas DamonZ 00:25:25 05/30/08 steamcleaning. (n/m) - twinturbineZ 20:55:01 05/29/08 What mounts are those/ how do you like them? (n/m) - mvtz 21:46:45 05/29/08 80 bucks from ebay, suprisingly they dont vibrate that much - cossiemodo2000 23:22:37 05/29/08 look pretty nice (n/m) - AntiHero 10:32:14 05/30/08 ha just did this...blown headgasket cleans pistons.. - Mike87T 22:26:39 05/29/08 Wait, cylinder 1 is on the LEFT from the front of the car? - BobbyT 23:20:30 05/29/08 Buy a fsm, its a good read :) - TTFairladyZ 23:52:17 05/29/08 I have one, printed out and bound, free of charge. - BobbyT 23:54:05 05/29/08 That's nice but actually reading it is the key. (n/m) - Bernie (NoVA) 06:45:26 05/30/08 my steam cleaned piston picture.. - Mike87T 08:52:47 05/30/08 or not.. - Mike87T 12:02:05 05/30/08 "403 Forbidden. You do not have access to xxxxx file - dogpile 17:39:58 05/30/08
Post a Followup	You cannot reply to this message because you are not logged in.
	General Forum