TwinTurbo.NET: Nissan 300ZX forum - just buy them and be done with it
Subject
just buy them and be done with it
Posted by
aliaZ
on May 29, 2008 at 7:29 AM
This message has been viewed
88
times.
In Reply To
Transmission bolts cost how much?!
posted by thehalfazn
on May 29, 2008 at 06:30 AM
Message
Why guess with an unknown bolt and have a failure? Not worth it IMHO, but then again I'm an anal retentive engineer
Follow Ups
Transmission bolts cost how much?!
-
thehalfazn
06:30:19 05/29/08
Shrug. Buy a used set. (n/m)
-
Bernie (NoVA)
07:04:00 05/29/08
just buy them and be done with it -
aliaZ
07:29:21 05/29/08
You need to consider what grade of bolt they are.
-
SlicktopTT
08:52:41 05/29/08
very good point (n/m)
-
nemo1080 (Iowa)
14:47:43 05/29/08
Pfft.. that's nothing
-
spicyZ
08:53:59 05/29/08
Don't bother checking on the compressor stud pricing (n/m)
-
Guapo
09:05:30 05/29/08
And where did you get your quote from? (n/m)
-
spicyZ
08:54:50 05/29/08
As the old bell helmet commercial said>>
-
RT1
10:08:04 05/29/08
These are high quality high hardness bolts...
-
Jonez
10:28:33 05/29/08
At minimum you'll need to match length, diameter, thread
-
just4kinks
12:40:58 05/29/08
i have multple sets of flywheel bolts (n/m)
-
spyhunterTT(nj)
17:09:53 05/29/08
Post a
Followup
You cannot reply to this message because you are not
logged in
.