Subject	Looking good...What's going on with your Z32?
Posted by	TheTwinZ (Peru) on May 15, 2008 at 4:22 PM
	This message has been viewed 91 times.
In Reply To	Progress pics of the 350Z Roll Cage posted by sfarrah on May 15, 2008 at 12:30 PM
Message	Always hear about the Z33, but never about the one I actually care (Z32) :) '90 Blue Nissan 300ZX Twin Turbo '91 White Nissan 300ZX Twin Turbo '93 Blue Mazda RX-7 R1 Twin Turbo (15K original miles!) VIDEO OF MY BLUE Z (Right click and Save As...)
Follow Ups	Progress pics of the 350Z Roll Cage - sfarrah 12:30:31 05/15/08 Very nice. - Waggz 12:33:31 05/15/08 looks very clean roll bar NICE!! SPL Parts rules!! (n/m) - Z-Roc@NEWOrleans 12:43:48 05/15/08 Sweet. (n/m) - Scotts94z32 13:31:17 05/15/08 i spy a cf fender vent on the TA car, such rice (n/m) - i_drive 14:14:45 05/15/08 come on, you wish you had it. ;) (n/m) - SkiFly01 14:22:14 05/15/08 that car is so not even close to being 'rice' (n/m) - genic 16:23:27 05/15/08 Shhhhh. Its sleeping. (n/m) - cjm300zxtt 16:28:52 05/15/08 Coming along very nicely, monkey. - Milo (SATX) 14:45:36 05/15/08 TPB's did a movie? oh man..i bet that thing is hilarious (n/m) - genic 16:24:06 05/15/08 It's been brought up a few times already... (n/m) - dogpile 18:01:49 05/15/08 i missed it (n/m) - genic 19:38:09 05/15/08 For lack of a better word....amazing. (n/m) - Milo (SATX) 18:29:17 05/15/08 nice roll cage - twiztidZ 15:12:00 05/15/08 Looking good...What's going on with your Z32? - TheTwinZ (Peru) 16:22:50 05/15/08 it's almost back together. - sfarrah 16:59:24 05/15/08 Great to hear that...Good luck! (n/m) - TheTwinZ (Peru) 17:01:37 05/15/08 i can't wait to see it tomorrow! (n/m) - Halo Z 17:15:03 05/15/08 Nice. Hopefully the cage will never be put to the test! (n/m) - XTZ 17:43:29 05/15/08 Agreed. Better to be safe than sorry. - sfarrah 17:46:53 05/15/08 Is it typical for a cage like that to not have the joints... - ZaXxon 08:32:07 05/16/08 it was just tacked in place in those pics while testing - sfarrah 09:16:03 05/16/08 How do they weld the back side of the joint? - ZaXxon 12:33:07 05/16/08 depends on the skill of the welder and the position of the - cha5e 14:35:28 05/16/08 Re: depends on the skill of the welder and the position of the - Dallas DamonZ 16:20:28 05/16/08
Post a Followup	You cannot reply to this message because you are not logged in.