| Message |
one by one, ove made and done a few from ebay, even though people booted my posts when i tried selling them here as masternismo1 or whatever, so here goes
... cut the plastic with a hot razor or sharp object
... get as thick a materaial as you can if going home depot style
... if clearing all four, you're gonna need to make a hole in the upper lenses in the proper area
... forget the spacers, use sealing cement in a few small spots around each lenses to keep the lense material firm with the rear of your lenses
... forget 300 degrees in the oven, 150, holding the lights with YouR hands, for about 5 minutes will be enough to heat the tar enough to separate and keep plastic nice and hard.
... separate slowly but firmly from each end little by little, very important, nothink will break bent or crack...any more Qs, post them here, no email, im sitting in my mis class (summer session.. hehe)
Went to Stage II Overnight and did nothing.. :-)
|
 |
