Subject	Clearing Tails (part2) HELP...>>>>
Posted by	minorleaguer on June 07, 2001 at 2:42 PM
	This message has been viewed 24 times.
Message	Ok... so I need to get spacers?... made of what ....the FAQ (twinturbo.org) doens't say anthing about them to my recolection?....I went and bought the exact clamps they used too. I will check the tails that are proped up onthe oven every min. Iheard YOU WILL melt the tails if you don't preheat the oven first.....can't afford new tails and a new engine =) ANY MORE ADVICE? Thanks, Justin
Follow Ups	Clearing Tails (part2) HELP...>>>> - minorleaguer 14:42:39 06/07/01 Re: Clearing Tails (part2) HELP...>>>> - Jason ZTT 14:44:46 06/07/01 read Part1 below... Last post by Dogpile (n/m) - minorleaguer 14:47:01 06/07/01 Re: read Part1 below... Last post by Dogpile - Jason ZTT 14:53:24 06/07/01 spacer? u don't need no stinken spacers! - Halo Z 15:33:32 06/07/01 all the info i can think of - Z 6370 15:14:34 06/07/01 Instead of the oven, why don't U just use a heat gun? - Scott@Bur-Vegas(N.C.) 18:35:48 06/07/01 If that doesn't work keep on puffing hot air from your mouth (n/m) - Ninjamonkey 19:11:57 06/07/01
Post a Followup	You cannot reply to this message because you are not logged in.