Subject	No you need to go to Napa and get the metal ones they sell.
Posted by	Piranha(AZ) on May 11, 2008 at 11:15 PM
	This message has been viewed 101 times.
In Reply To	will rhino ramps get me high enough to do my clutch? posted by beanz on May 11, 2008 at 10:19 PM
Message	They are quite a bit higher. I have used them to drop my transmission twice for my RPS clutches and need to buy some more in AZ here to drop it again :( They are the perfect height and IMO are better than jack stands because they give you room to work near the transmission where the jack stand points are. Fastest 1/4 mile time: 12.09 on stock engine/turbos/intercoolers Midwest Online Z Community Site Admin
Follow Ups	will rhino ramps get me high enough to do my clutch? - beanz 22:19:07 05/11/08 no. 6 ton jackstands leave me feeling quite safe under - Guapo 22:22:03 05/11/08 Agreed. (n/m) - Bernie (NoVA) 22:56:23 05/11/08 I think mine are 2.5 and 3 ton. 6 ton sound great - BigTDogg (MA) 10:27:46 05/12/08 You won't work under a car with out them, once you try - Bernie (NoVA) 12:19:07 05/12/08 agreed (n/m) - Guapo 13:07:51 05/12/08 should be high enough, remember that 12" inch ramps are - brentremley 22:23:57 05/11/08 Rhino ramps were not high enough for me... I did use them to - Piranha(AZ) 23:06:26 05/11/08 Rhino Ramps are maybe 8" high at best. At least the ones I - Eric(NJ) 22:52:22 05/11/08 I required at least 18" clearance from the floor to the - Gordo 93TT Daytona 23:08:08 05/11/08 2nd that. (n/m) - Inzane 11:07:02 05/12/08 No you need to go to Napa and get the metal ones they sell. - Piranha(AZ) 23:15:05 05/11/08 As long as you have solid jack stands, you're fine - spicyZ 09:05:53 05/12/08 thanks all... - beanz 11:29:18 05/12/08 Kwiklift would be nice, but four metal ramps will - Piranha(AZ) 11:53:23 05/12/08
Post a Followup	You cannot reply to this message because you are not logged in.