Subject	about machined plenums>>
Posted by	ztunerz on May 09, 2008 at 10:05 AM
	This message has been viewed 163 times.
In Reply To	I'll do one if you like. It'd take me only 5 or 10 minutes. posted by ni[X]it on May 09, 2008 at 08:23 AM
Message	we found the grommets seem to get cut over a period of time even after deburing the edges. Since the rubber is unsupported on the sides, it migh be getting expanded under boost or during the heating and cooling cycles of the engine, causing it to get cut. We machined some aluminum rings to fit around the top half of the rubber to prevent them from expanding and it appears to be working. Harry Formerly yellowzxtt " If it doesn't make it faster, i don't care " Please visit www.ztuner.com to GO FASTER
Follow Ups	Does Anyone have a write up how to machine lower - 300znick 19:42:19 05/08/08 Yes. - Bernie (NoVA) 23:01:08 05/08/08 I'm surprised no one has released a CAD drawing showing the - Inzane 00:54:05 05/09/08 It's really not that hard to work it out for yourself if you - Bernie (NoVA) 00:59:58 05/09/08 2nd (n/m) - Devi13 02:57:42 05/09/08 Re: It's really not that hard to work it out for yourself if - 300znew2me 08:04:20 05/09/08 I'll do one if you like. It'd take me only 5 or 10 minutes. - ni[X]it 08:23:49 05/09/08 Cool w. me. (n/m) - Bernie (NoVA) 08:27:04 05/09/08 that would be awesome.. then we can see how much metal - itsghoZt 09:09:18 05/09/08 That would be cool. I can't guarantee that I'm not going - Inzane 09:52:03 05/09/08 about machined plenums>> - ztunerz 10:05:48 05/09/08 Re: about machined plenums>> - itsghoZt 10:08:48 05/09/08 this was a one of deal but if there is interest .... - ztunerz 10:12:45 05/09/08 That is what I was working on as well. - Woody75 (Denver) 14:16:10 05/09/08 I'd be interested in getting a copy of that. Please. :-) (n/m) - Dave N 10:17:17 05/09/08 some one should DEFFINATLY post a write up - 300znick 15:01:10 05/09/08 Unless you have, or have access to, machine shop equipment - Dave N 15:05:53 05/09/08 Um, mine was already completely deburred - sorka 10:22:17 05/09/08 You are DEFINITELY the exception (n/m) - BigTDogg (MA) 11:03:55 05/09/08
Post a Followup	You cannot reply to this message because you are not logged in.