Subject	nah i wanted to do all aluminum but opted for this setup
Posted by	volcomstone550 on May 08, 2008 at 8:09 PM
	This message has been viewed 378 times.
In Reply To	ah, ok so you never had the ES subframe bushings in then? (n/m) posted by LJZTT on May 08, 2008 at 08:03 PM
Message	instead. cheaper too
Follow Ups	Homemade Hicas Eliminator with NA toe arms - volcomstone550 19:18:59 05/08/08 is it just me, or there a lot of room to flex there? - spotz 19:36:28 05/08/08 its on there VERY tight. doesnt budge when the car - volcomstone550 19:50:33 05/08/08 What kind of hardware are you using? I'd be concerned a bolt - Dave N 19:54:35 05/08/08 the best hardware for fitment is actually stock. - volcomstone550 19:57:19 05/08/08 Understood, but where you mounted to the subframe seems - Dave N 20:02:57 05/08/08 not to sure i understand your question - volcomstone550 20:08:03 05/08/08 off topic, but it appears you have ES bushings back there - LJZTT 19:49:43 05/08/08 SPL aluminum subframe bushings, ES diff bushings - volcomstone550 19:53:51 05/08/08 ah, ok so you never had the ES subframe bushings in then? (n/m) - LJZTT 20:03:37 05/08/08 nah i wanted to do all aluminum but opted for this setup - volcomstone550 20:09:19 05/08/08 How is the feel/sound? (n/m) - BlackholeZ 20:05:58 05/08/08 cant tell over the open 3" SZ downpipes yet! - volcomstone550 20:08:32 05/08/08 nice - BlackholeZ 11:53:08 05/09/08 works great for me. (n/m) - Guapo 12:07:28 05/09/08 Wasn't it a pain to get the solid bushings on!? and also - Ashman2k2 20:43:51 05/08/08 freezing them and a mallet helped but it was harder - volcomstone550 21:33:57 05/08/08 Im looking forward to the write-up. - Through The Eyes of the Dead 20:41:24 05/08/08 if you are worried about the ebay arms, the only - Antonio(AZ->NYC) 23:03:21 05/08/08
Post a Followup	You cannot reply to this message because you are not logged in.