TwinTurbo.NET: Nissan 300ZX forum - I didn't have a problem pulling it out
People Seeking Info
 
   


     
Subject I didn't have a problem pulling it out
     
Posted by ZEngineer (Dallas next month) on May 02, 2008 at 10:21 AM
  This message has been viewed 148 times.
     
In Reply To Hatch Strut Question posted by ooofoo on May 02, 2008 at 09:59 AM
     
Message Part Number: 9416k87
Steel 13 mm Ball Socket for M8 Thread Gas Spring with Threaded Ends
In stock at $2.34 Each

Some of us (including me) have had issues with those struts. They're longer than stock, so the hatch opens higher than intended. This causes the rubber washer nozzle to hit the roof bar, leading to a paint chip.

Also, allow me to recommend the 150lb model.

_________________________________________________________________________________

Im n0t Sarcastic (Kenny): not to over do it, but you're certainly the source of high-class Z mods
ZEngineer24: what do you mean by that?
Im n0t Sarcastic: I just mean, your Z is one I really admire


"The Z is the cause and the solution to all my problems" -- Me

"If your car was my car, I'd think it's broken"

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.