Subject	top/front windshield moulding
Posted by	THEDUCK on April 26, 2008 at 12:55 PM
	This message has been viewed 215 times.
Message	I have just had my windshield replaced only to find out i have a .200" gap from the body to the moulding. the guy who replaced the glass said it is for water to run around the top of the glass!!! bullcrap..i checked with COZ and he said that he sent me the correct moulding. Can somebody send me a picture of a correctly installed windshield so i can show my glass guy. Does any body know which way the moulding goes and how to correctly install it? He said he will come back next weekend because he needs to order new glass......what a chump....
Follow Ups	top/front windshield moulding - THEDUCK 12:55:18 04/26/08 On my Z I had them install a wider aftermarket trim - jzack 16:50:50 04/26/08 2nd, did the same on my Z. I like it better than oem. (n/m) - Woody75 (Denver) 16:59:40 04/26/08 That's what I did on mine. Did you happen to save that - ThunderZ 20:13:28 04/26/08 Sounds like he set the glass in to low. (n/m) - Spddracer 17:41:43 04/26/08 I bet he did not replace the molding fastener. It sits - doug8867 22:00:29 04/26/08
Post a Followup	You cannot reply to this message because you are not logged in.