Subject	Re: Audio help
Posted by	Uncledick on April 23, 2008 at 5:32 AM
	This message has been viewed 134 times.
In Reply To	Audio help posted by Evan(CA) on April 23, 2008 at 01:18 AM
Message	If this just stated to happen without any changes to the system I would look at the four speakers and the wires to them. To t/shoot disconect all four wires at the amp, and add one at a time back to the amp until the problem happens. Then when it does you know which one of the four cornners has an issue. Then look harder at the speaker,Blown? shorted wire? This should only take about 10 min to chk. Rich
Follow Ups	Audio help - Evan(CA) 01:18:32 04/23/08 sounds like ur amp is going into protect mode - Killer ZTT 01:45:14 04/23/08 Both 8. Which is what the manual calls for. (n/m) - Evan(CA) 02:10:51 04/23/08 Re: Audio help - DualZ (SF) 01:45:55 04/23/08 also check the impedance also - Killer ZTT 01:54:46 04/23/08 Re: Audio help - Uncledick 05:32:59 04/23/08 I'd bet money on a bad speaker, Ohm them out and find out - 550HPTT 06:51:57 04/23/08 Check at the amp outputs to see if it's a wiring issue (n/m) - BigTDogg (MA) 09:06:29 04/23/08 Protection mode can be caused by a few things: - just4kinks 16:17:53 04/23/08
Post a Followup	You cannot reply to this message because you are not logged in.