Subject	sounds like ur amp is going into protect mode
Posted by	Killer ZTT on April 23, 2008 at 1:45 AM
	This message has been viewed 111 times.
In Reply To	Audio help posted by Evan(CA) on April 23, 2008 at 01:18 AM
Message	what gage of power and ground wire r u using? they should be the same and capable of holding the amount of power u r putting to them
Follow Ups	Audio help - Evan(CA) 01:18:32 04/23/08 sounds like ur amp is going into protect mode - Killer ZTT 01:45:14 04/23/08 Both 8. Which is what the manual calls for. (n/m) - Evan(CA) 02:10:51 04/23/08 Re: Audio help - DualZ (SF) 01:45:55 04/23/08 also check the impedance also - Killer ZTT 01:54:46 04/23/08 Re: Audio help - Uncledick 05:32:59 04/23/08 I'd bet money on a bad speaker, Ohm them out and find out - 550HPTT 06:51:57 04/23/08 Check at the amp outputs to see if it's a wiring issue (n/m) - BigTDogg (MA) 09:06:29 04/23/08 Protection mode can be caused by a few things: - just4kinks 16:17:53 04/23/08
Post a Followup	You cannot reply to this message because you are not logged in.