Subject	testing gauges
Posted by	ouikikazz on April 08, 2008 at 10:06 AM
	This message has been viewed 91 times.
Message	i have some gauges that i haven't installed yet but i want to test them to make sure they all light up and what not, can i just put the red wire on the positive terminal and the black on a negative terminal of the battery without damaging the gauge?
Follow Ups	testing gauges - ouikikazz 10:06:16 04/08/08 Do it and post your results... - Z_Cherub 10:44:47 04/08/08 that is why all electronics should be on a fuse (n/m) - Atl300zxTT 11:04:09 04/08/08 Yep. Hindsight is 20/20. (n/m) - Z_Cherub 11:12:36 04/08/08 at least it was only a $100 Turbo Timer and not a $350+ - Atl300zxTT 11:29:37 04/08/08 True. - Z_Cherub 11:38:35 04/08/08 No track, just showed - Atl300zxTT 11:56:54 04/08/08 Clean. - Z_Cherub 12:12:02 04/08/08 they were there (n/m) - Atl300zxTT 12:13:58 04/08/08 where is the mud in the rim that I remember :) (n/m) - The Devils Z 12:47:07 04/08/08 cleaned out and remounted :) (n/m) - Atl300zxTT 12:49:10 04/08/08 If they are 12 volt gauges (more than likely) then yes. - Woody75 (Denver) 10:54:12 04/08/08 Re: If they are 12 volt gauges (more than likely) then yes. - ouikikazz 16:15:58 04/08/08
Post a Followup	You cannot reply to this message because you are not logged in.