Subject	Since you are doing the valve cover seals - might want
Posted by	jzack on April 06, 2008 at 10:19 AM
	This message has been viewed 88 times.
In Reply To	Just completed my first Plenum Pull posted by Madhatter10-6 on April 05, 2008 at 11:41 PM
Message	to also consider replacing the half-moon plugs at the rear of the exhaust CAM banks. Figure it will take about the same amount of time as the pull to get everything prep'd for the re-install. Cleaning up the valve covers and lower plenum area, some cleaning/mtce on the AAC at rear of upper plenum, re-RTVing the exhaust side valve covers, etc. IMPORTANT NOTE: There's a special trick to applying RTV to the exhaust valve covers/lower block (ie, extra RTV in the corners). If you don't know what this means - be sure to post for advice...
Follow Ups	Just completed my first Plenum Pull - Madhatter10-6 23:41:47 04/05/08 Nice. I am still amazed at all - ZXRider(SoCal) 23:43:52 04/05/08 agreed - Madhatter10-6 23:46:31 04/05/08 thats my next project when I can muster up the nuts and $... (n/m) - SaucyTabasco 23:51:06 04/05/08 makes it so much easier to work on later on down the road. - Waggz 01:09:20 04/06/08 Good job now get ready to bleed. Pulling those metal lines - 5280Z_nightstalker 02:05:43 04/06/08 Angle grinder and/or rotary tool (a.k.a. Dremel) work best. (n/m) - apudapus 10:09:48 04/06/08 I pulled mine off my parts car and had hose cutters and - Kong ZTT GT28RS MD 02:12:15 04/06/08 haha, you thought that was tough? - Spee 09:59:20 04/06/08 Since you are doing the valve cover seals - might want - jzack 10:19:46 04/06/08 important note???? - Madhatter10-6 12:28:58 04/06/08 Re: important note???? - Cade(PA) 12:42:01 04/06/08 How would valve cover gaskets solve a boost leak? (n/m) - Adam A. 19:16:36 04/06/08
Post a Followup	You cannot reply to this message because you are not logged in.