Subject	Angle grinder and/or rotary tool (a.k.a. Dremel) work best. (n/m)
Posted by	apudapus on April 06, 2008 at 10:09 AM
	This message has been viewed 98 times.
In Reply To	Good job now get ready to bleed. Pulling those metal lines posted by 5280Z_nightstalker on April 06, 2008 at 02:05 AM
Message
Follow Ups	Just completed my first Plenum Pull - Madhatter10-6 23:41:47 04/05/08 Nice. I am still amazed at all - ZXRider(SoCal) 23:43:52 04/05/08 agreed - Madhatter10-6 23:46:31 04/05/08 thats my next project when I can muster up the nuts and $... (n/m) - SaucyTabasco 23:51:06 04/05/08 makes it so much easier to work on later on down the road. - Waggz 01:09:20 04/06/08 Good job now get ready to bleed. Pulling those metal lines - 5280Z_nightstalker 02:05:43 04/06/08 Angle grinder and/or rotary tool (a.k.a. Dremel) work best. (n/m) - apudapus 10:09:48 04/06/08 I pulled mine off my parts car and had hose cutters and - Kong ZTT GT28RS MD 02:12:15 04/06/08 haha, you thought that was tough? - Spee 09:59:20 04/06/08 Since you are doing the valve cover seals - might want - jzack 10:19:46 04/06/08 important note???? - Madhatter10-6 12:28:58 04/06/08 Re: important note???? - Cade(PA) 12:42:01 04/06/08 How would valve cover gaskets solve a boost leak? (n/m) - Adam A. 19:16:36 04/06/08
Post a Followup	You cannot reply to this message because you are not logged in.