Subject	makes it so much easier to work on later on down the road.
Posted by	Waggz on April 06, 2008 at 1:09 AM
	This message has been viewed 80 times.
In Reply To	agreed posted by Madhatter10-6 on April 05, 2008 at 11:46 PM
Message	I remember my first plenum pull took me about 10 hours because of all that crap. The last time I took the plenum off took about 15 minutes, lol. ________________________________________________________________________________ |___________________________________*Rebuilding*__________________________________| **"What you did is no different than if I invited you to a big party, you funded some of the beer money, then came over, drank all the beer, asked us to go remove the guy in the bathroom so you could go, and proceeded to take a shit on the living room rug while we were doing it."** Greg (Dallas) 15:10:04 03/09/08
Follow Ups	Just completed my first Plenum Pull - Madhatter10-6 23:41:47 04/05/08 Nice. I am still amazed at all - ZXRider(SoCal) 23:43:52 04/05/08 agreed - Madhatter10-6 23:46:31 04/05/08 thats my next project when I can muster up the nuts and $... (n/m) - SaucyTabasco 23:51:06 04/05/08 makes it so much easier to work on later on down the road. - Waggz 01:09:20 04/06/08 Good job now get ready to bleed. Pulling those metal lines - 5280Z_nightstalker 02:05:43 04/06/08 Angle grinder and/or rotary tool (a.k.a. Dremel) work best. (n/m) - apudapus 10:09:48 04/06/08 I pulled mine off my parts car and had hose cutters and - Kong ZTT GT28RS MD 02:12:15 04/06/08 haha, you thought that was tough? - Spee 09:59:20 04/06/08 Since you are doing the valve cover seals - might want - jzack 10:19:46 04/06/08 important note???? - Madhatter10-6 12:28:58 04/06/08 Re: important note???? - Cade(PA) 12:42:01 04/06/08 How would valve cover gaskets solve a boost leak? (n/m) - Adam A. 19:16:36 04/06/08
Post a Followup	You cannot reply to this message because you are not logged in.