Subject	It's just a different point.
Posted by	na300zx (OH) on April 03, 2008 at 6:15 AM
	This message has been viewed 74 times.
In Reply To	Re: Sleeving cylinder on block posted by twin3037 on April 03, 2008 at 03:33 AM
Message	It isn't pointless. I would rather go .020" over or find another block, but you can sleeve it to fix a cylinder.
Follow Ups	Sleeving cylinder on block - Viper498 ( MO ) 14:50:35 04/02/08 How much is it going to cost - ZXRider(SoCal) 15:09:30 04/02/08 $85.00 to hone and sleeve... (n/m) - Viper498 ( MO ) 15:23:14 04/02/08 sleeves are kinda common in imports - ricerocketeer31 16:07:00 04/02/08 2nd - ZXRider(SoCal) 16:28:43 04/02/08 100% common on aluminum blocks. Not on cast iron blocks. (n/m) - AZHeat 00:14:40 04/03/08 Re: Sleeving cylinder on block - merlin3 17:18:39 04/02/08 Well I can definitely do that, but I just don't have the - Viper498 ( MO ) 21:53:55 04/02/08 Re: Sleeving cylinder on block - twin3037 03:33:52 04/03/08 It's just a different point. - na300zx (OH) 06:15:15 04/03/08
Post a Followup	You cannot reply to this message because you are not logged in.