Subject	Re: Sleeving cylinder on block
Posted by	twin3037 on April 03, 2008 at 3:33 AM
	This message has been viewed 114 times.
In Reply To	Sleeving cylinder on block posted by Viper498 ( MO ) on April 02, 2008 at 02:50 PM
Message	pretty much pointless on our cast iron blocks. I used to be a honda nerd and if you were tearing apart the motor you would re sleeve it the best ones were guaranteed to 55 psi to not fail but our cast iron blocks can hold that as long as you can get the rods, pistons and crank to do that same.
Follow Ups	Sleeving cylinder on block - Viper498 ( MO ) 14:50:35 04/02/08 How much is it going to cost - ZXRider(SoCal) 15:09:30 04/02/08 $85.00 to hone and sleeve... (n/m) - Viper498 ( MO ) 15:23:14 04/02/08 sleeves are kinda common in imports - ricerocketeer31 16:07:00 04/02/08 2nd - ZXRider(SoCal) 16:28:43 04/02/08 100% common on aluminum blocks. Not on cast iron blocks. (n/m) - AZHeat 00:14:40 04/03/08 Re: Sleeving cylinder on block - merlin3 17:18:39 04/02/08 Well I can definitely do that, but I just don't have the - Viper498 ( MO ) 21:53:55 04/02/08 Re: Sleeving cylinder on block - twin3037 03:33:52 04/03/08 It's just a different point. - na300zx (OH) 06:15:15 04/03/08
Post a Followup	You cannot reply to this message because you are not logged in.