Subject	Re: Sleeving cylinder on block
Posted by	merlin3 on April 02, 2008 at 5:18 PM
	This message has been viewed 121 times.
In Reply To	Sleeving cylinder on block posted by Viper498 ( MO ) on April 02, 2008 at 02:50 PM
Message	I'd just see if you can bore it out enought to get bigger pistons like .020 over. Usually sleeves are used on open deck blocks. 1990 300zx 2+2 twin turbo, 2003 350z greddy twin turbo
Follow Ups	Sleeving cylinder on block - Viper498 ( MO ) 14:50:35 04/02/08 How much is it going to cost - ZXRider(SoCal) 15:09:30 04/02/08 $85.00 to hone and sleeve... (n/m) - Viper498 ( MO ) 15:23:14 04/02/08 sleeves are kinda common in imports - ricerocketeer31 16:07:00 04/02/08 2nd - ZXRider(SoCal) 16:28:43 04/02/08 100% common on aluminum blocks. Not on cast iron blocks. (n/m) - AZHeat 00:14:40 04/03/08 Re: Sleeving cylinder on block - merlin3 17:18:39 04/02/08 Well I can definitely do that, but I just don't have the - Viper498 ( MO ) 21:53:55 04/02/08 Re: Sleeving cylinder on block - twin3037 03:33:52 04/03/08 It's just a different point. - na300zx (OH) 06:15:15 04/03/08
Post a Followup	You cannot reply to this message because you are not logged in.