Subject	all I can tell you
Posted by	vorpalZ on March 31, 2008 at 10:38 PM
	This message has been viewed 60 times.
In Reply To	Re: Thats what I was thinking as well.. posted by ConVerTT on March 31, 2008 at 08:48 PM
Message	is that I have run mine many times in sub-zero temps with no fuel issues at all (I check obsessively). The key is to pressure test before you install in a water bath. Tighten the AN fittings for no leaks and you will be fine. Regards, My Zs are hybrid vehicles, they run on gasoline and money times change, people change, but the Z32 still kicks ass. - apudapus 16:46:02 06/15/07 I was more wondering how you set your climate control to 22* lol, it would be that fastest freezer on wheels! - Briscoe'sZ32 (NJ) 23:15:44 02/05/07 You have *got* to be getting a cut from B&B :D - SeedyROM 15:24:29 08/16/06 What do you think B&B stands for? - YugoBernie (NoVA) 15:57:09 08/16/06
Follow Ups	Advisory for those people installing 300 degree fuel rails - spyhunterTT + 93Vert(nj) 18:17:19 03/31/08 Did the injector o-rings leak as well? - Kandy Orange Z 20:05:49 03/31/08 On that same car, no (n/m) - spyhunterTT + 93Vert(nj) 21:43:20 03/31/08 Re: Did the injector o-rings leak as well? - OldSquidz 22:43:07 03/31/08 While I'm not calling into question that you had leaks, - ni[X]it 20:12:01 03/31/08 You beat me to it - same question below VVVVV (n/m) - ConVerTT 20:33:22 03/31/08 My exact thought when reading the post. - ENVYMYZ 21:19:29 03/31/08 Why use o-rings over a copper seal? - Spddracer 21:38:04 03/31/08 The oring was actually split apart in this case as well - spyhunterTT + 93Vert(nj) 21:51:41 03/31/08 I was also thinking about this - spyhunterTT + 93Vert(nj) 21:42:29 03/31/08 Are the AN fittings steel or aluminum? - ConVerTT 22:01:23 03/31/08 If as supplied by 300d, they are Aluminum for that reason. - ni[X]it 09:55:35 04/01/08 Not part of the kit... - Dallas DamonZ 10:29:19 04/01/08 Wait a minute.... - ConVerTT 20:31:26 03/31/08 Thats what I was thinking as well.. - Kandy Orange Z 20:44:33 03/31/08 Re: Thats what I was thinking as well.. - ConVerTT 20:48:56 03/31/08 all I can tell you - vorpalZ 22:38:52 03/31/08 Re: Advisory for those people installing 300 degree fuel rails - Dallas DamonZ 00:26:00 04/01/08 used the orings, they flared out and nearly split on the - spyhunterTT + 93Vert(nj) 16:45:51 04/01/08 user error (n/m) - ZEngineer 09:59:09 04/01/08
Post a Followup	You cannot reply to this message because you are not logged in.