Subject	Are the AN fittings steel or aluminum?
Posted by	ConVerTT on March 31, 2008 at 10:01 PM
	This message has been viewed 63 times.
In Reply To	I was also thinking about this posted by spyhunterTT + 93Vert(nj) on March 31, 2008 at 09:42 PM
Message	As i recall, aluminum and steel expand and contract at different rates. I am guessing but following your story if the leak is between the fitting and the rail then the rail must be expanding faster than the fitting which I think would imply that that the fitting is steel, not aluminum. I am guessing here - is there a mechanical engineer in the house? Pics Cruizin' Topless on December 26th Engine Bay Pics 719 miles on the turbo'ed NA 'VerTT and counting Versus TransAm Versus Audi S4 Biturbo Versus Cadillac XLR NA's are for Sissies Sudden Loss of Boost is Heartstopping First Driving Impression Preliminary Dyno Results Acknowledgments
Follow Ups	Advisory for those people installing 300 degree fuel rails - spyhunterTT + 93Vert(nj) 18:17:19 03/31/08 Did the injector o-rings leak as well? - Kandy Orange Z 20:05:49 03/31/08 On that same car, no (n/m) - spyhunterTT + 93Vert(nj) 21:43:20 03/31/08 Re: Did the injector o-rings leak as well? - OldSquidz 22:43:07 03/31/08 While I'm not calling into question that you had leaks, - ni[X]it 20:12:01 03/31/08 You beat me to it - same question below VVVVV (n/m) - ConVerTT 20:33:22 03/31/08 My exact thought when reading the post. - ENVYMYZ 21:19:29 03/31/08 Why use o-rings over a copper seal? - Spddracer 21:38:04 03/31/08 The oring was actually split apart in this case as well - spyhunterTT + 93Vert(nj) 21:51:41 03/31/08 I was also thinking about this - spyhunterTT + 93Vert(nj) 21:42:29 03/31/08 Are the AN fittings steel or aluminum? - ConVerTT 22:01:23 03/31/08 If as supplied by 300d, they are Aluminum for that reason. - ni[X]it 09:55:35 04/01/08 Not part of the kit... - Dallas DamonZ 10:29:19 04/01/08 Wait a minute.... - ConVerTT 20:31:26 03/31/08 Thats what I was thinking as well.. - Kandy Orange Z 20:44:33 03/31/08 Re: Thats what I was thinking as well.. - ConVerTT 20:48:56 03/31/08 all I can tell you - vorpalZ 22:38:52 03/31/08 Re: Advisory for those people installing 300 degree fuel rails - Dallas DamonZ 00:26:00 04/01/08 used the orings, they flared out and nearly split on the - spyhunterTT + 93Vert(nj) 16:45:51 04/01/08 user error (n/m) - ZEngineer 09:59:09 04/01/08
Post a Followup	You cannot reply to this message because you are not logged in.