Subject	u can cut them in half with a dremel
Posted by	genic on June 05, 2001 at 9:41 PM
	This message has been viewed 37 times.
In Reply To	Boost jet/Welding tip help! posted by Only1Z on June 05, 2001 at 09:38 PM
Message	doesnt matter if they are 3/4 inch long either better not to cut them..cause you might get some stuff in the hole and make it smaller...which is more boost...and flash. www.askthedrunk.com : it's chicken soup for the drunken soul
Follow Ups	Boost jet/Welding tip help! - Only1Z 21:38:18 06/05/01 u can cut them in half with a dremel - genic 21:41:20 06/05/01
Post a Followup	You cannot reply to this message because you are not logged in.