Subject	link inside.
Posted by	AntiHero on March 26, 2008 at 1:35 PM
	This message has been viewed 53 times.
In Reply To	Modifying Urethane Rear Valence posted by pionkej on March 26, 2008 at 10:53 AM
Message	[ http://www.pivco.net/Merchant2/merchant.mv?Screen=PROD&Store_Code=P&Product_Code=DN660&Category_Code=Bond ] cut out the details to make a flat hole, tape a peice of flexible hobby plastic covered in thin plastic (Saran wrap?) to the back side. mix up a few batches of that stuff and fill the hole and build the area up a bit. sand down after... Im not professional, but ive used a similar product for a much smaller job and was happy with it. your milliage may vary Antihero These 2530's ain't half bad ;)
Follow Ups	Modifying Urethane Rear Valence - pionkej 10:53:11 03/26/08 why do you have a single exhaust set up? (n/m) - Alan(NJ) 10:55:09 03/26/08 I'm guessing two in two out on a dual chamber muffler (n/m) - SC300Z 11:14:11 03/26/08 Personal perference maybe? (n/m) - ali300zx 11:18:37 03/26/08 Exactly. (n/m) - pionkej 13:14:33 03/26/08 Why not? Dr. Kuah's car showed it can work well (n/m) - Atl300zxTT 11:57:17 03/26/08 Not sure if this would work - SC300Z 11:18:05 03/26/08 Yeah...I thought about this. - pionkej 13:18:20 03/26/08 if you're asking this question, you should prob just let a - Atl300zxTT 11:55:38 03/26/08 Well, I know that I can modify the 99' fascia... - pionkej 13:20:25 03/26/08 Re: Well, I know that I can modify the 99' fascia... - pionkej 13:23:06 03/26/08 link inside. - AntiHero 13:35:02 03/26/08 Thanks. It is definately worth a shot... - pionkej 14:33:52 03/26/08
Post a Followup	You cannot reply to this message because you are not logged in.