Subject	Re: The instructions have you placing the vinyl on the OEM face
Posted by	ttzcadet on March 13, 2008 at 3:47 PM
	This message has been viewed 102 times.
In Reply To	The instructions have you placing the vinyl on the OEM face posted by JBender on March 13, 2008 at 03:02 PM
Message	So does anyone have a source for the face in the second picture (the non sticker speedo face)? Also, I'm guessing you'd have to setup a voltage divider with a resistor in order to run the 180 speedo with a stock speed sensor- anyone done this lately? Thanks
Follow Ups	Follow-up on SR-71 speedometers on eBay - JBender 14:47:02 03/13/08 So, you're building an SR-71? (n/m) - Adam A. 14:51:59 03/13/08 Hehe no, just a little NA rice - JBender 14:54:17 03/13/08 Stop wasting money. (n/m) - Adam A. 14:57:16 03/13/08 it doesn't even have a center point for the needle, it'll - Cap927(Boston) 14:54:10 03/13/08 I personally wasn't able to pull the needle and remove the - ZEngineer 14:56:42 03/13/08 The instructions have you placing the vinyl on the OEM face - JBender 15:02:49 03/13/08 someone with a SR71 might be able to confirm if it is only - Atl300zxTT 15:04:24 03/13/08 Re: The instructions have you placing the vinyl on the OEM face - ttzcadet 15:47:40 03/13/08 Gauge clusters pre-92 have a potentiometer, so you can use a - JBender 16:50:55 03/13/08 There is a reason I stay away from ebay (n/m) - Audicon 15:12:06 03/13/08 Use a GPS unit. Much more accurate at those speeds. - AZHeat 15:19:02 03/13/08 probably not. (n/m) - zfreak(Denver) 15:55:02 03/13/08 I have an SR-71 Brochure at home, I'll look. - Honad 16:29:06 03/13/08 this is going to sound off the wall, bbut i have had z32's s - pearlyellowtt 18:16:40 03/13/08 eh, i just searched it. Fast, but stupid name i think. (n/m) - pearlyellowtt 18:22:00 03/13/08 Unnecessary: - Hawkin"Z" 18:21:41 03/13/08 I wonder if it will look like OEM at night? - Spongerider :) 18:49:11 03/13/08 Piece of crap but once again I still sell the factory > - Oppaman Z 21:57:55 03/13/08
Post a Followup	You cannot reply to this message because you are not logged in.