TwinTurbo.NET: Nissan 300ZX forum - Re: subframe bushings/spacers?
Subject
Re: subframe bushings/spacers?
Posted by
immortaliZed
on March 11, 2008 at 7:59 AM
This message has been viewed
65
times.
In Reply To
subframe bushings/spacers?
posted by ouikikazz
on March 11, 2008 at 04:40 AM
Message
[
http://www.twinturbo.net/net/viewmsg.aspx?forum=general&msg_id=2018625
]
Good luck with the project. :)
Follow Ups
subframe bushings/spacers?
-
ouikikazz
04:40:59 03/11/08
I think the Urethane would be easier to press in, your best
-
Eishozzzz
06:54:26 03/11/08
Very easy to press in, getting out the old ones can be a
-
LJZTT
17:19:02 03/11/08
Re: subframe bushings/spacers? -
immortaliZed
07:59:28 03/11/08
You don't need the spacers if you go solid bushings (n/m)
-
Guapo
09:35:36 03/11/08
AL or urethane...
-
Barry (NJ)
10:31:31 03/11/08
No they are not...
-
Bernie (NoVA)
13:13:29 03/11/08
Maybe band-aid was the wrong term...
-
Barry (NJ)
13:32:02 03/11/08
It is the wrong term.
-
Bernie (NoVA)
13:47:47 03/11/08
can't use spacers with aftermarket bushings
-
spyhunterTT(nj)
17:29:09 03/11/08
Post a
Followup
You cannot reply to this message because you are not
logged in
.