Subject	I think the Urethane would be easier to press in, your best
Posted by	Eishozzzz on March 11, 2008 at 6:54 AM
	This message has been viewed 44 times.
In Reply To	subframe bushings/spacers? posted by ouikikazz on March 11, 2008 at 04:40 AM
Message	bet is to call Kuah at spl and ask him, Good luck.
Follow Ups	subframe bushings/spacers? - ouikikazz 04:40:59 03/11/08 I think the Urethane would be easier to press in, your best - Eishozzzz 06:54:26 03/11/08 Very easy to press in, getting out the old ones can be a - LJZTT 17:19:02 03/11/08 Re: subframe bushings/spacers? - immortaliZed 07:59:28 03/11/08 You don't need the spacers if you go solid bushings (n/m) - Guapo 09:35:36 03/11/08 AL or urethane... - Barry (NJ) 10:31:31 03/11/08 No they are not... - Bernie (NoVA) 13:13:29 03/11/08 Maybe band-aid was the wrong term... - Barry (NJ) 13:32:02 03/11/08 It is the wrong term. - Bernie (NoVA) 13:47:47 03/11/08 can't use spacers with aftermarket bushings - spyhunterTT(nj) 17:29:09 03/11/08
Post a Followup	You cannot reply to this message because you are not logged in.