|
1. Fill up tank full of gas. 2. Park car and let idle for a few moments, then write down on a piece of paper where each needle is pointing to ( all while the car is idling )? 3. Turn car off and remove gauge cluster from car. 4. Everything is out of the car and ready to pull the needles. 5. Use a needle nose pliars to hold the shaft which contains the needle @ one end and needle motor @ the other(behind face gauges). 6. Carefully remove the needle head off of the needle shaft ( while a needle nose pliars is holding the needle shaft so it does not come out of the motor when removing the needle head )? 7. Put on overlays. 8. Put gauge cluster back in car and start the car. 9. After car has been idling for a few moments put needle heads back on according to where I marked them on paper? Is that it? Do I got it?
Where can I get a needle puller?
 
|
