Subject	It depends on the shape of you cylinders
Posted by	Kyle(Houston) on March 09, 2008 at 3:24 PM
	This message has been viewed 65 times.
In Reply To	What's your thought posted by ZXRider(SoCal) on March 09, 2008 at 03:20 PM
Message	You would need to check the cylinders and the pistons you are going to use to make sure the piston to wall clearances are within spec. If so then you would be fine to use stock pistons with new rings. Kyle "Grumpy Bear" Puckett Import Parts Pro Phone: 281-288-0700 AIM: KyleatIPP Yahoo: KyleatIPP
Follow Ups	Weiso pistons and eagle rods - RedTTZ91(OK) 14:37:58 03/09/08 The wiseco piston noise problem has been fixed. - aliaZ 14:42:07 03/09/08 Would you happen to know if Wiseco - ZXRider(SoCal) 14:49:11 03/09/08 2nd (n/m) - THEDUCK 14:50:45 03/09/08 Not off the shelf - Kyle(Houston) 15:14:49 03/09/08 Re: Not off the shelf - RedTTZ91(OK) 15:17:12 03/09/08 I have used the wiseco/eagle combo in cars running 700+ Rwhp (n/m) - Kyle(Houston) 15:22:23 03/09/08 What's your thought - ZXRider(SoCal) 15:20:30 03/09/08 It depends on the shape of you cylinders - Kyle(Houston) 15:24:03 03/09/08 Would I be able to check those - ZXRider(SoCal) 15:27:53 03/09/08 I'd let a machine shop measure that for you - aliaZ 15:34:25 03/09/08 Gotcha - ZXRider(SoCal) 15:44:55 03/09/08 plastigage gives you a ballpark measurement - aliaZ 18:00:37 03/09/08 I see - ZXRider(SoCal) 18:40:17 03/09/08 Are you doing the short block assembly or the machinist? - AZHeat 18:43:26 03/09/08 I'm hoping that I can manage all the assembly - ZXRider(SoCal) 18:53:16 03/09/08 Getting kinda pricey and time consuming there, huh? - apudapus 23:29:46 03/09/08 Would it have been better to go with IPP block, YES - ZXRider(SoCal) 23:55:15 03/09/08 I noticed on eagle rods, there is more big end side - AZHeat 15:02:33 03/09/08 JE pistons or weiscos? - RedTTZ91(OK) 15:29:50 03/09/08 I'd get the wisecos and spend the money you saved - aliaZ 15:36:15 03/09/08 Its getting tuned regardless. - RedTTZ91(OK) 15:37:30 03/09/08 I wasn't able to notice any difference in oil pressure - aliaZ 15:31:17 03/09/08 any other recommendations - RedTTZ91(OK) 15:40:48 03/09/08
Post a Followup	You cannot reply to this message because you are not logged in.