Subject	works for me...
Posted by	beanz on February 28, 2008 at 6:31 PM
	This message has been viewed 41 times.
In Reply To	Use it as intended, IMO... posted by whitepearlz on February 28, 2008 at 06:25 PM
Message	i have no desire to try to get smart with the install just for the sake of it. i just didn't want to pass up some smarter connector for this if it existed and i just didn't know about it. thanks for the confirmation that just stripping the wire and screwing it down is reasonable. andrew davidoff
Follow Ups	stupid question about wire connectors on my amp - beanz 18:00:02 02/28/08 Re: stupid question about wire connectors on my amp - olyar15 18:06:23 02/28/08 i used ring connectors. - z_samurai 18:12:00 02/28/08 Hard to tell from the picture - but I've used crimp type - jzack 18:13:05 02/28/08 Use it as intended, IMO... - whitepearlz 18:25:35 02/28/08 works for me... - beanz 18:31:47 02/28/08 No problem. Sometimes the easiest way is the best. ;) (n/m) - whitepearlz 18:34:49 02/28/08 shameless picture - resorb (NJ) 19:52:06 02/28/08 wish i had enough room like you! - itsghoZt 09:29:22 02/29/08 I'm 5'11. (n/m) - resorb (NJ) 12:50:56 02/29/08 you could use these: - zxhoon 20:19:10 02/28/08 You must be short. - Evan(CA) 22:41:16 02/28/08 Re: You must be short. - zgene4 23:40:46 02/28/08 LOL. 5'9" FTW! There's a good inch or two of clearance - whitepearlz 10:59:42 02/29/08
Post a Followup	You cannot reply to this message because you are not logged in.