Subject	Any stock con-rod will do. just re-number it. (n/m)
Posted by	LitlElvis on February 27, 2008 at 11:32 PM
	This message has been viewed 38 times.
In Reply To	Does anyone know? (n/m) posted by Viper498 ( MO ) on February 27, 2008 at 10:49 PM
Message
Follow Ups	Rod Bearing Failure on TT engine I am going to Rebuild - Viper498 ( MO ) 17:58:28 02/27/08 Rebello is offering 10, 20 & 30 + bearing for our TT's - Izzy 19:23:46 02/27/08 Get a good used crank? (n/m) - ZXRider(SoCal) 19:31:51 02/27/08 I got one for sale. $160 shipped. - na300zx (OH) 19:41:35 02/27/08 I may take you up on that. It would cost a lot to ship - Viper498 ( MO ) 21:15:22 02/27/08 If you want i have some rods and pistons i could send you. (n/m) - Sleeper_TTZ(SeKy) 00:49:44 02/28/08 I figured it owuld be ~$40 or $50 for shipping - na300zx (OH) 07:22:06 02/28/08 Get a good used one. ur current one will most likely need to - MikeVar82 20:38:05 02/27/08 Why isn't it good to re-cut. As lond as its not more than... - Sleeper_TTZ(SeKy) 00:48:32 02/28/08 The Connnecting Rod is also scored on that particular - Viper498 ( MO ) 21:13:02 02/27/08 Does anyone know? (n/m) - Viper498 ( MO ) 22:49:47 02/27/08 Any stock con-rod will do. just re-number it. (n/m) - LitlElvis 23:32:54 02/27/08 Sweet, thanks for the response. (n/m) - Viper498 ( MO ) 23:35:13 02/27/08 You should do this... - icsamerica 23:32:29 02/27/08 Wow, I wasn't sure if I could do that. I went out to the - Viper498 ( MO ) 23:38:30 02/27/08 I'll try this on the con-rod as well. (n/m) - Viper498 ( MO ) 23:39:27 02/27/08 You could take it to a shop and they can tell you if its... - Sleeper_TTZ(SeKy) 00:46:57 02/28/08 Seriously? No... goto a MacHine shop! - Adam A. 08:10:27 02/28/08 It's not rocket science and can be do by anyone of us... - icsamerica 10:05:25 02/28/08 Does the damage in the pictures on my main post - Viper498 ( MO ) 00:23:39 02/28/08 Re: Rod Bearing Failure on TT engine I am going to Rebuild - dirtbiker194 00:36:13 02/28/08 I had same thing happen - Daniel(CA) 19:02:14 02/28/08
Post a Followup	You cannot reply to this message because you are not logged in.