Subject	Already got one (n/m)
Posted by	collegeboy on February 26, 2008 at 11:03 PM
	This message has been viewed 24 times.
In Reply To	Did you get yourself an aluminum vise teeth to hold posted by AZHeat on February 26, 2008 at 10:27 PM
Message
Follow Ups	Any good site out there with some AN fitting instructions? - collegeboy 22:25:48 02/26/08 Did you get yourself an aluminum vise teeth to hold - AZHeat 22:27:09 02/26/08 Already got one (n/m) - collegeboy 23:03:40 02/26/08 Male threads fit into the female threads. YMMV, however. (n/m) - Guapo 22:40:14 02/26/08 Heck yes! Perfect! - collegeboy 23:06:35 02/26/08 Use a dremel cutting wheel, much easier. Also use - AZHeat 23:08:58 02/26/08 Will do...I'm actually using the nylon threaded hose - collegeboy 23:37:04 02/26/08 use a cut off wheel, cleanest and ,easiest by far (n/m) - sparkie 23:22:34 02/26/08 Yes, wash the inside out afterwards though. (n/m) - RSR 07:57:28 02/27/08 Just cut through the steel braid with the cut off wheel - sparkie 08:41:15 02/27/08 Bookmarked, thanks! (n/m) - 91300zxttkid 23:24:24 02/26/08 ROFLMAO @ step 6 - Broke_as_**** 02:32:44 02/27/08 For those that have ever been worried... - collegeboy 02:36:30 02/27/08 To be fair, - RSR 07:58:37 02/27/08 2nd (n/m) - aliaZ 08:28:27 02/27/08 i recently posted some pic on my FAQ accusump install (n/m) - sawbonez 07:19:00 02/27/08
Post a Followup	You cannot reply to this message because you are not logged in.