Subject	bead blast it and coat at will (n/m)
Posted by	ztunerz on February 26, 2008 at 7:46 PM
	This message has been viewed 26 times.
In Reply To	Not trying to thread jack, posted by J-Mart on February 26, 2008 at 04:37 PM
Message
Follow Ups	ceramic coating MSP manifolds - WazTTed 16:25:04 02/26/08 Can't say I've heard any reasons not to coat the outside of - Furb (NoVa) 16:31:17 02/26/08 there is no issue coating cast iron manifolds - aliaZ 16:31:59 02/26/08 Not trying to thread jack, - J-Mart 16:37:34 02/26/08 As long as the surface is clean it's no problem (n/m) - 550HPTT 16:43:21 02/26/08 bead blast it and coat at will (n/m) - ztunerz 19:46:54 02/26/08 We coat them all the time - infact i recommend coating them - ztunerz 19:46:31 02/26/08 What about the warning on SZ's website? - BlackholeZ 20:28:11 02/26/08 "Coatings may flake off inside the manifold and.." - Furb (NoVa) 20:38:50 02/26/08 Yeah, I'd lol for days if someone came on here - BlackholeZ 21:49:51 02/26/08 I have my turbine housings coated, No problems at all. (n/m) - AZHeat 22:29:48 02/26/08 Inside too? - BlackholeZ 02:58:04 02/27/08 Yes the inside . (n/m) - AZHeat 08:26:46 02/27/08
Post a Followup	You cannot reply to this message because you are not logged in.