Subject	Re: Ramey Z HD Idler Pulley Studs
Posted by	txq45 on February 26, 2008 at 6:01 PM
	This message has been viewed 957 times.
In Reply To	Ramey Z HD Idler Pulley Studs posted by apudapus on February 26, 2008 at 05:14 PM
Message	Had the same thing happen to me except it was the top lower intake stud... I was using a kevlar belt and was blessed to find that it had only throw the car out of time and did not bend any valves... Surprised me since I was on 7000 rpm's when it stopped..I never change a belt unless I change the studs..
Follow Ups	Ramey Z HD Idler Pulley Studs - apudapus 17:14:33 02/26/08 2nd - J-Mart 17:17:57 02/26/08 Currently installed :) (n/m) - 550HPTT 17:32:58 02/26/08 Re: Ramey Z HD Idler Pulley Studs - txq45 18:01:38 02/26/08 Are these OEM or hardened after market ones? (n/m) - AZHeat 20:10:20 02/26/08 The Ramey Z ones? - apudapus 23:42:27 02/26/08 This is a very inexpensive and necessary purchase. - TriniTT 18:13:16 02/26/08 How do you get the old ones out? - 91300zxttkid 23:37:56 02/26/08 You can either do the double-nut method or use a vise grip - apudapus 23:45:01 02/26/08 that or ... - Guapo 23:50:06 02/26/08 Currently Installed. Fit is good and I think they're grade10 (n/m) - EricTTZ 10:43:46 02/27/08
Post a Followup	You cannot reply to this message because you are not logged in.