Subject	I have it, but the tip is too short b/c I'm using the EGR
Posted by	Dark Diver on February 26, 2008 at 3:32 AM
	This message has been viewed 35 times.
In Reply To	yes, I tried and it did not work ..get the greddy posted by The Devils Z on February 25, 2008 at 06:07 PM
Message	bolt :
Follow Ups	Did anyone connect a Greddy EGT gauge to another probe ? - Dark Diver 16:21:40 02/25/08 Your testing it off the car? >> - MikeVar82 17:37:01 02/25/08 I assume propane torch? (n/m) - AZHeat 19:01:20 02/25/08 No, I'm using a heat gun for the Greddy probe which is - Dark Diver 03:17:10 02/26/08 I'm sure it's based off resistance...try it again - twinturbineZ 17:44:10 02/25/08 I asked Greddy if there were a specific capacitor or - Dark Diver 03:21:25 02/26/08 yes, I tried and it did not work ..get the greddy - The Devils Z 18:07:33 02/25/08 I have it, but the tip is too short b/c I'm using the EGR - Dark Diver 03:32:32 02/26/08 Try reversing Polarity? A K TC outputs a mV DC signal. - kkrofft (OH) 20:20:22 02/25/08 Yes, I checked the polarity and tried to reverse it, - Dark Diver 03:33:51 02/26/08
Post a Followup	You cannot reply to this message because you are not logged in.