Subject	After about 10 phone calls this morning
Posted by	TTFairladyZ on February 21, 2008 at 10:58 AM
	This message has been viewed 118 times.
In Reply To	For those of you still with a stock TT flywheel posted by TTFairladyZ on February 20, 2008 at 07:25 PM
Message	I finally found a machinist who was able to create the step for me. The guy worked on it as soon as I walked in the place and also pressed out my old throwout bearing and pressed in the new one, all for $65. Thanks again Dave for the email tech help :) And for those drag racers out there who don't already know this, stick with the stock flywheel. Launching is cakework compared to my old RPS. 1990 Nissan 300ZXTT Stage III+
Follow Ups	For those of you still with a stock TT flywheel - TTFairladyZ 19:25:43 02/20/08 If your machinist can't put a 0.008" step in the flywheel - Guapo 19:28:07 02/20/08 2nd. the stock flywheel is a beast - nemo1080 19:29:42 02/20/08 This is true, I shaved down quite a bit on my NA FW, lighter (n/m) - SkiFly01 22:33:36 02/20/08 lightweight....werd (n/m) - CRAZZEPETE. 11:11:49 02/21/08 Can they put the step in even when its currently flush? (n/m) - TTFairladyZ 19:31:51 02/20/08 Yes. (n/m) - Dave N 19:34:32 02/20/08 Cool. Thanks Dave and Guapo (n/m) - TTFairladyZ 19:36:41 02/20/08 Here's what I do: - Dave N 19:41:54 02/20/08 Because Dave is old and talks too much: - Bernie (NoVA) 20:21:39 02/20/08 pretty (n/m) - zgene4 20:48:34 02/20/08 Yup. (n/m) - Dave N 22:03:16 02/20/08 Agreed. - zazupilot 21:09:53 02/20/08 I've done the step on every TT clutch I replaced where the - Dave N 19:28:32 02/20/08 After about 10 phone calls this morning - TTFairladyZ 10:58:50 02/21/08 That's why I am sticking with stock . I found a local - AZHeat 11:24:32 02/21/08
Post a Followup	You cannot reply to this message because you are not logged in.