Subject	I love this picture :-)
Posted by	ImTheDevil on February 20, 2008 at 11:44 PM
	This message has been viewed 446 times.
In Reply To	tips for dremeling plastic? posted by beanz on February 20, 2008 at 09:04 PM
Message	Minus the yellow interior of course. The hole was cut with a Dremel and I believe I used a 2 part epoxy to hold it in place where the timer meets the opening on the inside. Rand wires with spade ends to extend the harness to reach. It is also still in that same location and has been since late 2001.
Follow Ups	tips for dremeling plastic? - beanz 21:04:09 02/20/08 take your time, trim a little at a time. (n/m) - Bernie (NoVA) 21:09:27 02/20/08 big 2nd..... be patient - tyler@boostpro.net 01:26:48 02/21/08 If you have a GReddy or HKS timer - TriniTT 21:11:08 02/20/08 scribe or mark the outline...carefully...then - twinturbineZ 21:11:14 02/20/08 forgot to add...use a stepped drill bit..unibit..less chance - twinturbineZ 21:12:53 02/20/08 these are some of my favorites - Cap927(Boston) 21:15:25 02/20/08 for the timer installation in the clock location you'll just - Cap927(Boston) 21:19:56 02/20/08 A tappered Dremel diamond bit works good too - used - jzack 22:27:59 02/20/08 Consider a file. - Got Z? 23:04:39 02/20/08 I love this picture :-) - ImTheDevil 23:44:37 02/20/08 mirror controls, shock adjustments, - BlackholeZ 00:00:52 02/21/08 Side mirror defrost, mock up shot - ImTheDevil 00:08:16 02/21/08 Early Z32? - BlackholeZ 00:15:08 02/21/08 yup (n/m) - Spee 00:25:01 02/21/08 91, defrost and color should give it away :-) (n/m) - ImTheDevil 10:42:13 02/21/08 Very nice. - Got Z? 00:09:58 02/21/08 That is a good spot for it man.. good idea (n/m) - Kong ZTT GT28RS MD 01:24:05 02/21/08 pretty clean...my mirror heaters are used very rarely (n/m) - CRAZZEPETE. 07:49:25 02/21/08 I need to do that with mine. (n/m) - Barry'z (NJ) 08:23:28 02/21/08 now that's a spot i hadn't thought of...nice. (n/m) - beanz 08:34:35 02/21/08 definitley about to install my EDFC in that position this - mogaffar 08:42:18 02/21/08 That's very nice. (n/m) - TT XTZ 12:56:56 02/21/08
Post a Followup	You cannot reply to this message because you are not logged in.