Subject	Consider a file.
Posted by	Got Z? on February 20, 2008 at 11:04 PM
	This message has been viewed 25 times.
In Reply To	tips for dremeling plastic? posted by beanz on February 20, 2008 at 09:04 PM
Message	Good for removing small amounts of material.
Follow Ups	tips for dremeling plastic? - beanz 21:04:09 02/20/08 take your time, trim a little at a time. (n/m) - Bernie (NoVA) 21:09:27 02/20/08 big 2nd..... be patient - tyler@boostpro.net 01:26:48 02/21/08 If you have a GReddy or HKS timer - TriniTT 21:11:08 02/20/08 scribe or mark the outline...carefully...then - twinturbineZ 21:11:14 02/20/08 forgot to add...use a stepped drill bit..unibit..less chance - twinturbineZ 21:12:53 02/20/08 these are some of my favorites - Cap927(Boston) 21:15:25 02/20/08 for the timer installation in the clock location you'll just - Cap927(Boston) 21:19:56 02/20/08 A tappered Dremel diamond bit works good too - used - jzack 22:27:59 02/20/08 Consider a file. - Got Z? 23:04:39 02/20/08 I love this picture :-) - ImTheDevil 23:44:37 02/20/08 mirror controls, shock adjustments, - BlackholeZ 00:00:52 02/21/08 Side mirror defrost, mock up shot - ImTheDevil 00:08:16 02/21/08 Early Z32? - BlackholeZ 00:15:08 02/21/08 yup (n/m) - Spee 00:25:01 02/21/08 91, defrost and color should give it away :-) (n/m) - ImTheDevil 10:42:13 02/21/08 Very nice. - Got Z? 00:09:58 02/21/08 That is a good spot for it man.. good idea (n/m) - Kong ZTT GT28RS MD 01:24:05 02/21/08 pretty clean...my mirror heaters are used very rarely (n/m) - CRAZZEPETE. 07:49:25 02/21/08 I need to do that with mine. (n/m) - Barry'z (NJ) 08:23:28 02/21/08 now that's a spot i hadn't thought of...nice. (n/m) - beanz 08:34:35 02/21/08 definitley about to install my EDFC in that position this - mogaffar 08:42:18 02/21/08 That's very nice. (n/m) - TT XTZ 12:56:56 02/21/08
Post a Followup	You cannot reply to this message because you are not logged in.