Subject	depends on how you programmed it >>>
Posted by	ztunerz on February 15, 2008 at 7:22 PM
	This message has been viewed 36 times.
In Reply To	Hotter the air the less mass = less fuel. posted by AZHeat on February 15, 2008 at 05:00 PM
Message	there is a table in there where you can correct ait temp vs the primary fuel table. Anyhow if preventing heat soak is your thing then its best to put the ait in the nose of the car or use a isolator type fitting in the plenum. Even the intake tubing will cause the same heat soak issues. Harry Formerly yellowzxtt " If it doesn't make it faster, i don't care " Please visit www.ztuner.com to GO FASTER
Follow Ups	Those with AEM EMS, where did you place your - AZHeat 15:47:08 02/15/08 Welded a bung on the hardpipe right in from of the PS TB - collegeboy 16:15:22 02/15/08 Ummmn - ztunerz 16:17:44 02/15/08 Hotter the air the less mass = less fuel. - AZHeat 17:00:34 02/15/08 depends on how you programmed it >>> - ztunerz 19:22:13 02/15/08 Basically you tune the car under normal conditions - sparkie 19:48:32 02/15/08 What type of sensor AEM comes with? - sparkie 19:39:14 02/15/08
Post a Followup	You cannot reply to this message because you are not logged in.