Subject	Those with AEM EMS, where did you place your
Posted by	AZHeat on February 15, 2008 at 3:47 PM
	This message has been viewed 118 times.
Message	IAT sensor? I was reading the AEM forums that if you install it directly into the intake manifold then it will get heat soaked and give a false reading causing the engine to run lean. It is recommended in the intercooler piping. Can you post pictures where it is placej? I know it is not a small sensor like an water injection nozzle. ************************************************************ "Carrying a gun is like having a second cock. If your other cock could kill someone. " - Movie Superbad. "You are all about to get f*cked by the long d*ck of the law" - Superbad "It's better to be dead and cool than alive and uncool" Don Johnson in -Harley Davidson and the Marlboro Man "Yes, I know more then JWT. Someone has to be the top dog, and it just so happens it's me." Nixit
Follow Ups	Those with AEM EMS, where did you place your - AZHeat 15:47:08 02/15/08 Welded a bung on the hardpipe right in from of the PS TB - collegeboy 16:15:22 02/15/08 Ummmn - ztunerz 16:17:44 02/15/08 Hotter the air the less mass = less fuel. - AZHeat 17:00:34 02/15/08 depends on how you programmed it >>> - ztunerz 19:22:13 02/15/08 Basically you tune the car under normal conditions - sparkie 19:48:32 02/15/08 What type of sensor AEM comes with? - sparkie 19:39:14 02/15/08
Post a Followup	You cannot reply to this message because you are not logged in.