Subject	pistons and rods don't need to come out
Posted by	Bezza on February 06, 2008 at 2:30 PM
	This message has been viewed 55 times.
In Reply To	Yes it does need to be removed. posted by Bezza on February 06, 2008 at 01:42 PM
Message	Oh and pistons and rods don't need to be removed if you are just going to replace bearings. I don't know if it is worth replacing piston rings too... probably :)
Follow Ups	Some questions regarding engine condition - ZXRider(SoCal) 12:56:53 02/06/08 looks well used to me, but nothing major. (n/m) - nemo1080 13:02:01 02/06/08 depends..how did the engine run prior to removal? - mossyoak 13:08:11 02/06/08 Looks just like mine did, Might want to take it to a. - Sleeper_TTZ 13:08:49 02/06/08 Aye Clinton, how is your VG coming along? Haven't been - TyreeZtt (SeKy) 15:09:37 02/06/08 Its on hold right now. Just thinking about going back to.... - Sleeper_TTZ 17:20:00 02/06/08 Cost? - lazer(AK) 13:10:13 02/06/08 A can of Engine Degreaser works wonders for dirt and grime (n/m) - TTFairladyZ 13:24:41 02/06/08 You better make sure you get that stuff off... - CameronSF 14:21:23 02/06/08 I was in the same position 2 months ago - Bezza 13:25:55 02/06/08 Does the crank need to be removed for that? - ZXRider(SoCal) 13:33:42 02/06/08 Yes it does need to be removed. - Bezza 13:42:59 02/06/08 RB26 rebuild guide. - Bezza 13:47:53 02/06/08 pistons and rods don't need to come out - Bezza 14:30:14 02/06/08 Gotcha, - ZXRider(SoCal) 15:40:15 02/06/08 "... looks like a war zone"... a nicely organized war zone - apudapus 13:32:02 02/06/08 lol no kidding - ZXRider(SoCal) 13:40:03 02/06/08 You need some shelves and racks to get stuff off floor. (n/m) - Gordo 93TT Daytona 15:22:56 02/06/08 It's in the works =) - ZXRider(SoCal) 15:39:24 02/06/08 Looks pretty good up top. Now down below might be a - TyreeZtt (SeKy) 15:10:29 02/06/08 Looks pretty good, but you should change the bearings and - TheTwinZ (Peru) 15:27:18 02/06/08 you've come this far... dont be a fool! - icsamerica 16:59:59 02/06/08 It looks better than mine did. - Josef(Houston) 19:40:28 02/06/08
Post a Followup	You cannot reply to this message because you are not logged in.