Subject	not sure about the zi
Posted by	gt300zxtt on January 30, 2008 at 6:33 PM
	This message has been viewed 30 times.
In Reply To	cool, do you think there is any risk of it wearing off from posted by Jkova300z on January 30, 2008 at 06:08 PM
Message	the powdercoat holds up pretty well when tightening bolts. but, as you can imagine durability of the finish is inversely proportional to the torque applied. smaller bolts will not require much torque, and should be ok. i have done flywheel bolts among many others, and they have held up to the torque as well.
Follow Ups	Has anyone tried recoating their 10mm bolts with zinc or - Jkova300z 17:41:22 01/30/08 eastwood.com - gt300zxtt 18:03:17 01/30/08 cool, do you think there is any risk of it wearing off from - Jkova300z 18:08:57 01/30/08 not sure about the zi - gt300zxtt 18:33:19 01/30/08 I use titanium bolts on anything that spins - collegeboy 19:58:51 01/30/08 you are a richer man than i.... (n/m) - gt300zxtt 20:10:25 01/30/08 Doubt it.....I'm just dumber =) (n/m) - collegeboy 20:16:25 01/30/08 Re: I use titanium bolts on anything that spins - derekinthez 23:15:48 01/30/08 i don't see prices on there. - apudapus 11:26:53 01/31/08 I just purchased some POR-15. - zQuikonE 18:11:28 01/30/08 becareful when using it on body panels and whatnot - spyhunterTT(nj) 18:13:55 01/30/08 I plan to use it on some rusted spots under the car - zQuikonE 18:23:41 01/30/08 I replaced all the bolts in my car with stainless ones - collegeboy 18:37:59 01/30/08 where did you get them from, i can only find ones that dont - Jkova300z 19:18:08 01/30/08 You most likely have a FASTENAL company near by.. - Kong ZTT GT28RS MD 19:42:29 01/30/08 ps.. You should use some anti-seize on the threads.. - Kong ZTT GT28RS MD 00:45:47 01/31/08 Denton Bolt Company right by my house - collegeboy 19:51:47 01/30/08 local hardware stores - gt300zxtt 19:58:09 01/30/08 all? (n/m) - SactoTodd 20:43:16 01/30/08 Yup...pretty much everyone I could get to. - collegeboy 08:37:08 01/31/08 Do not use stainless on stressed bolts - zorpman1 09:38:05 01/31/08 also... SS is approximately the equivelent of Grade "5" bolt - Kong ZTT GT28RS MD 00:36:50 02/01/08
Post a Followup	You cannot reply to this message because you are not logged in.