TwinTurbo.NET: Nissan 300ZX forum - Those connecters are fine...
Subject
Those connecters are fine...
Posted by
Barry'z (NJ)
on January 28, 2008 at 5:08 PM
This message has been viewed
43
times.
In Reply To
not permanently installed? So why go through all that
posted by Cap927(Boston)
on January 28, 2008 at 01:12 PM
Message
it's these that aren't very reliable.
It's a new link
Follow Ups
S-AFCII harness install
-
Barry'z (NJ)
20:10:08 01/27/08
looking clean Barry
-
90AztecTT
20:15:22 01/27/08
is there a write-up for "knock sensor correction settings"? (n/m)
-
enthuZiast
20:39:10 01/27/08
I haven't looked that deep yet. (n/m)
-
Barry'z (NJ)
21:06:09 01/27/08
Yes
-
Broke_as_****
21:27:03 01/27/08
Why not use these?
-
Bountywolf
20:39:41 01/27/08
I have used those in the past... tend to come loose. (n/m)
-
jcieslik
20:51:04 01/27/08
same here, there a bit troublesome (n/m)
-
550HPTT
20:52:04 01/27/08
Yes, and as Crim noted...
-
Barry'z (NJ)
21:03:12 01/27/08
Looks good, except the manual explicitly says not to use
-
Crim
20:46:12 01/27/08
isnt that the same thing hes doing?? (n/m)
-
Bountywolf
20:49:02 01/27/08
They are talking about these...
-
Barry'z (NJ)
20:56:48 01/27/08
P.S. The type of connector I'm using is supplied
-
Barry'z (NJ)
21:05:30 01/27/08
I've been using them for a while now and I haven't had any
-
spyhunterTT(nj)
17:24:31 01/28/08
I'm been using them for my boost controller...
-
Barry'z (NJ)
18:36:56 01/28/08
what are those connectors called?
-
Tikigod (Denver)
21:51:39 01/27/08
Bullet terminals, or bullet connectors...
-
Barry'z (NJ)
22:28:19 01/27/08
thanks (n/m)
-
Tikigod (Denver)
22:39:55 01/27/08
not permanently installed? So why go through all that
-
Cap927(Boston)
13:12:37 01/28/08
Those connecters are fine... -
Barry'z (NJ)
17:08:51 01/28/08
personally I don't trust either, from installing many
-
Cap927(Boston)
09:51:21 01/29/08
why tune it if ur not going to use it?
-
naZeer (Dallas)
20:09:11 01/28/08
I'm going to have the car tuned, and plan on
-
Barry'z (NJ)
22:16:53 01/28/08
Post a
Followup
You cannot reply to this message because you are not
logged in
.